Description

Overview

Trailer axle assembly supports heavy trailer wheel-end and brake service where a complete 10-stud axle setup needs matching by track, PCD, stud length and lubrication type.

This 20″ axle assembly suits 10-stud 285.75 PCD applications with 1850mm track, long studs and grease lubrication. It also suits workshop replacement or build work where the axle setup calls for an FN tapered spindle, 11.5t axle capacity and GP drum brake configuration.

Features

• 10-stud 285.75 PCD hub pattern for matching trailer wheel-end setups.
• 1850mm track, also commonly referred to as 73″ track.
• M22 x 1.5 x 123 long studs for aluminium rim applications.
• Manual slack adjuster configuration with grease-lubricated wheel ends.

Specifications and Materials

This trailer axle assembly uses a round 127 x 15mm axle beam with FN tapered spindle configuration. The axle carries 11.5t capacity, 420 x 180mm GP drum brake setup, enclosed 1 1/2″ 10-spline camshaft and ABS-ready pole ring and sensor block arrangement.

Part number: AP0230FGN07.

Use the manufacturer product guide for axle configuration guidance

Compatibility and Fitment

Match the axle to the trailer track, wheel PCD, spindle type, brake hardware, stud length and lubrication requirement before ordering. Also confirm suspension seat position, brake chamber setup and slack adjuster requirements against the existing axle or trailer build specification.

These cross-references show where this part replaces the part numbers and applications listed. Some installations may need minor changes. KHKF22AG15L1850N30S, KF22AG15L1850N30S.

Compliance and Safety

Use qualified heavy vehicle repair procedures when fitting a trailer axle assembly. Check axle alignment, brake adjustment, bearing preload, wheel nut torque and ABS sensor setup before returning the trailer to service. If any brake, hub or suspension part does not match, resolve the fitment issue before installation.

Trailer Applications

Heavy trailer workshops use this trailer axle assembly on axle replacement, trailer refurbishment and build work where a 10-stud 285.75 PCD, 1850mm track grease axle matches the existing trailer specification. It suits applications that require long studs and manual slack adjuster configuration.

Cross-reference and Suitability

This part cross-references to or suits the following equivalent part numbers and compatible alternatives:

Why Choose ICS Trailers

ICS Trailers supplies axle and suspension parts for heavy trailer servicing, rebuilds and fleet maintenance. Compare the existing axle code and measurements before ordering so the replacement matches the trailer setup.

Browse more Axle Parts