Description

Overview

Zebra left hand rear 400 x 100mm class 1A reflective sticker provides a clear rear-side visibility marker for trailers that use rear marking plates. Because the reflective face returns light back toward approaching traffic, it helps other drivers pick up the trailer outline sooner in low light. The long life sticker format also keeps the profile low, so it suits applications where a rigid plate is not preferred.

Features

• Class 1A reflective finish to AS 4001.1 for strong visibility
• Long life vinyl sticker format for a low-profile install
• High resolution print, so the zebra pattern stays sharp
• Designed for multi-year outdoor exposure with a stated 7+ year service life in many environments

Specifications and Materials

• Position: rear left-hand marker
• Size: 400 x 100mm
• Material: long life vinyl sticker
• Australian standard: AS 4001.1 Class 1A

Read the Transport WA guidance on rear marking plates for overview requirements and placement basics

Part number: CA7235S.

Compatibility and Fitment

Zebra left hand rear 400 x 100mm class 1A reflective sticker suits trailer rear marking locations where you need a left-hand rear marker in a compact size. Before you apply it, confirm the mounting area is flat, clean, and free of silicone or polish residues, because contamination can reduce adhesion. If the trailer has rivets, joins, or deep corrugations in the mounting zone, move to a smoother panel section so the sticker can bond evenly.

For best results, position the sticker square to the trailer and align it with any matching right-hand marker. Then press from the centre outward to push out trapped air. If you apply it in cold weather, warm the surface first, otherwise the adhesive may not wet-out properly.

Compliance and Safety

This marker sticker is intended for rear marking plate visibility on heavy vehicle trailers, and it supports the reflective classes referenced by AS 4001.1. If your operation falls under heavy vehicle standards, note that vehicles over 12,000kg GVM and trailers over 10,000kg GTM may require retro-reflective rear marking plates depending on the applicable rules. After installation, keep the face clean because road grime and fuel film can reduce retro-reflectivity.

Also check the sticker during walk-around inspections. Replace it if the print becomes unreadable, the edges lift, or the reflective layer is badly scratched.

Trailer Applications

Use Zebra left hand rear 400 x 100mm class 1A reflective sticker on flat tops, tippers, and general freight trailers that run rear marking plate patterns. It is also a practical choice for replacing a damaged rear marker without drilling, so it can reduce downtime during routine maintenance. If you are refreshing a set, fit the matching right-hand marker at the same time so both sides present consistent visibility.

Why Choose ICS Trailers

You get clear selection details and practical fitment guidance, so you can order the right rear marker the first time. We also stock a broader range of trailer signage and safety items, which helps you standardise markings across a fleet and keep spares on hand.

Browse Signs and Safety at ICS Trailers via Browse Signs and Safety at ICS Trailers to view related trailer marking products