Description

Overview

The 1/2 hose barb joiner connects two equal lengths of flexible hose through a straight, double-ended brass union. Each end fits inside 1/2″ internal-diameter hose, creating an inline connection for extending a run or removing a damaged section. The larger barb size must match the hose bore rather than its outside measurement.

Features

• Equal 1/2″ hose barb connections at both ends
• Straight barb-to-barb mender configuration
• One-piece brass construction with no threaded joints
• Multiple retaining ribs support secure hose engagement

Specifications and Materials

Configuration: straight hose barb joiner.

Connection 1: 1/2″ hose barb.

Connection 2: 1/2″ hose barb.

Material: brass.

Part number: 06-007-08.

Review the Parker brass hose barb fitting guide for barb-to-barb configurations and hose connection guidance

Compatibility and Fitment

Measure the hose internal diameter before ordering. A hose with a 1/2″ outside diameter will usually require a smaller barb, so matching by the outside measurement can produce an incorrect fit. Cut each hose end square, push it fully over the ribs and use a suitable hose clamp or crimped ferrule. The clamp must sit behind the leading barb without crushing or cutting the hose.

These cross-references show where this part replaces the part numbers and applications listed. Some installations may need minor changes. GP-574-08, GP57408

Compliance and Safety

Release all line pressure before removing hose or fitting the joiner. Check the hose for cracks, hardening, swelling and damage around the previous connection. Confirm that the hose, clamp and brass fitting suit the fluid, temperature and working pressure of the system, then pressure-test the completed joint and inspect both ends for leakage or movement.

Trailer Applications

A 1/2 hose barb joiner suits compatible flexible hose in truck, trailer and workshop pneumatic systems where a straight inline connection is required. It can also support suitable water, coolant or general fluid lines when every component matches the medium and operating conditions. This fitting does not replace a threaded adaptor, compression union or push-to-connect fitting.

Cross-reference and Suitability

This part cross-references to or suits the following equivalent part numbers and compatible alternatives:

Why Choose ICS Trailers

ICS Trailers supplies brass hose fittings, clamps, pneumatic connectors and air line components for heavy vehicle repairs. When replacing an unknown joiner, compare the hose bore, barb diameter and retaining method before ordering.

Browse more Air Fittings