Description

Overview

Camilleri Tarps Rear Tarp Cable Bracket is designed to support front to rear tarping systems on tipping bodies. It helps keep the rear cable path controlled so your cover runs smoothly during daily loading and unloading. Because tarp hardware sits on the outside of the body, this bracket is built around durability and practical mounting.

Features

This rear bracket set is supplied as a left-hand and right-hand pair for common front to rear tarp layouts. It also suits both steel and aluminium bodies, which helps when you are replacing hardware across mixed fleets.

• Rear cable bracket set for tipping bodies with front to rear tarp systems
• Supplied as an LH/RH pair for balanced rear mounting
• Zinc coated finish for corrosion resistance in outdoor use
• Mounting points and alignment slots to assist clean fit-up

Specifications and Materials

Part number: TTRADJ.
This Camilleri Tarps Rear Tarp Cable Bracket is intended for exterior mounting where road spray and abrasion are common, so corrosion protection and solid fastener support matter. For general guidance on tarp accessories and parts, see Camilleri Tarps accessories and parts overview which covers typical cables and pulleys used in tip truck tarping systems

Compatibility and Fitment

Confirm your existing tarp layout is a front to rear style on a tipping body before ordering, then check that your rear cable routing matches your current hardware. This cross-reference listing means this part is a suitable replacement for the part numbers and applications shown. Some changes in installation may be required. RBA LH/RH, RBALHRH

Compliance and Safety

Tarp systems sit alongside load control, so you should still restrain and cover loads in line with local rules and site requirements. Also inspect brackets, pulleys, and cables regularly, because worn hardware can create sudden slack or snagging at the rear of the body. If you see cracking, bent mounting faces, or ovalled holes, replace the hardware before it damages the tarp or creates a roadside hazard.

Trailer Applications

This bracket suits tip truck and tipper trailer bodies using a front to rear tarp system where the rear cable needs stable guidance. It can also be used during repairs after cable wear, bracket damage, or a body rebuild that changes rear mounting geometry. If your setup uses a different tarp style, choose hardware matched to that system so tension and run-up stay consistent.

Cross-reference and Suitability

This part cross-references to or suits the following equivalent part numbers and compatible alternatives:

Use the list above only as an interchange aid, and always validate the physical mounting and cable path on your body.

Why Choose ICS Trailers

ICS Trailers backs practical parts selection with straightforward advice for heavy vehicle hardware and tarping accessories. You can also Browse Container, Van & Tipper parts at ICS Trailers to keep your body and tarp setup running reliably