Description

Overview

Zebra left hand rear 800 x 100mm class 1 reflective sign gives a clear rear-side visual marker for trailers. Because it uses Class 1 reflective material, it helps improve visibility at night and in low light. The aluminium plate keeps the sign rigid, so it sits flat and stays readable when mounted correctly.

This style of rear marker sign suits heavy vehicle trailer setups that use rear marking plates or equivalent rear visibility markings. It also works as a direct replacement when an existing plate is faded or damaged. If you are matching an existing set, confirm you are selecting the left-hand rear position before ordering.

Features

• Class 1 reflective finish for strong night visibility
• Rigid aluminium plate for stable mounting and long service life
• High resolution print, so the pattern stays sharp and readable
• UV protection to reduce fading in outdoor use

Specifications and Materials

• Type: rear left-hand marker sign
• Size: 800 x 100mm
• Material: aluminium plate
• Standard: AS 4001.1 Class 1

Refer to the Department of Infrastructure vehicle standards bulletin index for official bulletin references on rear marking plates

Part number: CA7231.

Compatibility and Fitment

Zebra left hand rear 800 x 100mm class 1 reflective sign suits the rear left-hand side position on trailers where a flat rear marking plate or marker sign mounts to a clean, solid surface. For best results, mount it square and level so the sign reads correctly from behind. Also check that the plate will not be obscured by equipment, hinges, load hardware, or tarps once the trailer is loaded.

Before installation, clean the mounting surface so dirt does not trap moisture behind the plate. If you are replacing a worn plate, remove old adhesive or fasteners and then confirm the plate sits flat. Otherwise, a bowed plate can reduce durability and make the sign harder to read.

Compliance and Safety

Zebra left hand rear 800 x 100mm class 1 reflective sign is intended to support trailer visibility markings used on heavy vehicles. However, requirements can vary by vehicle type and operating conditions, so confirm the correct marking configuration for your setup. After fitting, keep the reflective face clean because road grime can reduce reflectivity over time.

Inspect the sign during routine checks, and replace it if it becomes cracked, badly scratched, or visibly faded. If you notice loose mounting points, fix them early so the plate does not flex or detach in service.

Trailer Applications

This rear marker sign suits trailers that use rear marking plates as a visual cue for following traffic. It is a common fit on flat tops, tippers, and general freight trailers where rear visibility matters, especially during night driving or wet weather. Match the left-hand rear position with the corresponding right-hand plate if you are fitting a pair.

Why Choose ICS Trailers

You get clear product selection info and practical fitment guidance, so you can order with confidence. If you are refreshing a fleet, you can also standardise markings across trailers and replace plates before they become hard to see. When you need help matching trailer safety signage, our range covers common heavy vehicle marking items and workshop essentials.

Browse Signs and Safety at ICS Trailers via Browse Signs and Safety at ICS Trailers to find more trailer marking options