Description

Overview

Straight Winch Handle 550mm gives you better leverage when you tension a strap winch on trailers, utes, and transport gear. It suits situations where the factory handle has gone missing or you want a reliable spare in the toolbox. Because the handle is straight and full length, you can apply smooth, controlled turns without fighting short travel or poor grip. If your restraint gear gets used daily, that extra leverage can reduce fatigue and help you reach consistent strap tension.

When you choose a replacement handle, match the handle style and drive interface to your winch, and then check that the handle clears guards and side rails through a full rotation. Also make sure the grip sits where your hand naturally loads the bar, because it helps you keep control when the strap tightens.

Features

• 550mm bar length so you get practical leverage without over-reaching
• 20mm diameter bar built for regular workshop and roadside use
• Heat treated construction for durability under repeated winding loads
• Rubber grip so your hand stays planted when the handle gets oily or wet

Specifications and Materials

This Straight Winch Handle 550mm uses a 20mm diameter heat treated steel bar with a rubber hand grip, and it suits general strap winch winding duties.
Part number: CA4805.
Read the Transport Victoria securing loads guidance so you can review restraint practices and checks before you travel.

Compatibility and Fitment

This cross-reference listing means this part is a suitable replacement for the part numbers and applications shown. Some changes in installation may be required. No confirmed cross references were found for this part.

Compliance and Safety

Use this handle only with a compatible winch and rated restraint equipment, and stop if you feel binding or damaged teeth in the winch. Also keep hands clear of pinch points because a loaded winch can kick back if the mechanism slips. If you work around heavy loads, check straps, winches, and anchor points before each trip and re-check tension after the first short section of road. For best control, wind with steady pressure rather than sudden jerks, and wear gloves when you handle webbing and hardware.

Trailer Applications

This Straight Winch Handle 550mm suits strap winches used on flat tops, semi trailers, tag trailers, and plant or machinery trailers. It also works well as a spare for fleet vehicles, because it helps drivers tension webbing with consistent leverage when they swap between different trailers. For workshop fit-ups, keep one on hand so you can test winch operation during servicing. If a driver loses a handle on site, a spare can keep the load restrained and the job moving.

Cross-reference and Suitability

No confirmed cross references or interchange numbers were found for this part based on available sources.

Why Choose ICS Trailers

ICS Trailers supplies practical load restraint hardware with local support, so you can keep trailers working instead of waiting on parts. Browse Hardware at ICS Trailers to find compatible load restraint hardware for your setup.