Description

Overview

Strap Winder 50mm is a clamp-on tool that rolls loose tie-down webbing into a tight coil so you store straps neatly and keep the trailer deck organised. It suits 50mm webbing straps and clamps onto 5 inch gate pockets, so drivers can pack straps away quickly between drops. Because the winding fork controls the tail, it helps reduce tangles and saves time compared with hand-rolling.

Features

• Clamp-on bracket suits 5 inch gate pockets for quick fit-up
• Fork and handle design winds 50mm webbing into a compact roll
• Steel construction for durability in day-to-day freight work
• Strap Winder 50mm helps keep straps tidy for faster redeployment

Specifications and Materials

• Suits webbing width: 50mm
• Mounting: clamp-on to 5 inch gate pocket
• Construction: steel

Part number: CA4932.
For general load restraint guidance, the NTC provides a Load Restraint Guide overview that covers safer tie-down methods and performance requirements.

Compatibility and Fitment

Fit the clamp to a clean, square gate pocket so the tool sits rigid and the handle clears surrounding hardware. Feed the strap tail through the fork, then turn the handle to wind the strap into a tight coil. This cross-reference listing means this part is a suitable replacement for the part numbers and applications shown. Some changes in installation may be required. SW5000

Compliance and Safety

This tool supports safe work practices by reducing loose strap tails and keeping load restraint gear stored properly. However, it does not change the rated capacity of your straps or winches, so always use compliant webbing and hardware for the job. If a strap shows cuts, melted fibres, or damaged stitching, replace it instead of winding it for re-use. Keep hands clear of the fork while turning, and stop if the strap snags.

Trailer Applications

Use Strap Winder 50mm on curtain siders, flat tops, and drop decks where 50mm tie-down straps get used across repeated deliveries. It also suits fleets that run multiple drivers because the clamp-on setup makes it easy to move the tool between trailers. For example, drivers can wind straps as they unload, then stow them before the next pickup.

Cross-reference and Suitability

This part cross-references to or suits the following equivalent part numbers and compatible alternatives:

Confirm your strap width and mounting style before ordering.

Why Choose ICS Trailers

ICS Trailers supplies trailer-fit load restraint and hardware with practical product selection support. You also get straightforward ordering and parts knowledge that matches real transport use, so you can keep downtime down. If you are refreshing strap management across a fleet, this Strap Winder 50mm keeps storage consistent and reduces strap mess from one run to the next.
Browse Hardware parts at ICS Trailers in the Hardware category at ICS Trailers