Description

Overview

Galvanised square trailer door hinge supports rear doors on compatible semi-trailer vans and curtain-sider bodies. Its over-seal profile lets the hinge pass over a PVC door seal, helping the door move without fouling the sealing edge.

Features

• Galvanised steel construction.
• Over-seal profile clears the PVC door seal.
• Square form for compatible van and curtain-sider rear doors.

Specifications and Materials

Product type: square rear door hinge. Material: galvanised steel. Configuration: over-seal.

Part number: CV2070.

For zinc coating information, see the Galvanizers Association of Australia guide to metallic zinc coatings for steel

Compatibility and Fitment

Compare the hinge profile, mounting position, PVC seal clearance and mating butt before fitting. Because the over-seal shape controls clearance, a flat or differently offset hinge may interfere with the seal or alter rear door alignment.

Related Parts

Check the related service parts below against the trailer setup before ordering.

Compliance and Safety

After fitting, swing the rear door through its full travel and confirm the hinge clears the seal. Also inspect the mating butt, mounting points and door structure for wear, cracking or distortion.

Trailer Applications

This hinge suits compatible semi-trailer van and curtain-sider rear doors where the hinge must bridge over a PVC door seal.

Why Choose ICS Trailers

An over-seal hinge needs to match the existing door geometry and PVC seal clearance, not just the general square shape. If the old hinge is bent, worn or missing, send ICS Trailers photos of the rear door edge, seal and hinge butt. We can help compare the over-seal profile and mating hardware before installation, so the repaired door can swing freely and close against the seal without the hinge fouling it.

Browse more Container, Van & Tipper