Description

Overview

The D Shape Rubber Bump Stop 900mm is a shock absorbent docking buffer used to help prevent damage to a truck, trailer, and cargo during contact or low speed bumps. It suits loading areas, body protection points, and trailer interfaces where you want a durable sacrificial surface.

Because the profile is a round D shape, it spreads contact across a broad face rather than a sharp edge. As a result, it can reduce panel denting and paint scuffing when a door, tray, or docking point touches down. The black rubber surface also hides marks better than light colours, so it keeps a tidy look for longer.

Features

• Heavy duty shock absorbent buffer for repeated contact points
• Round D profile designed to spread impact over a wider face
• No pre drilled mounting holes, so you can self drill to suit
• Cut to length when you need a shorter buffer section

Specifications and Materials

Part number: CA7104.

Type: round D shape bump stop, also known as a moulded docking buffer.

Overall size: 900mm length x 110mm width x 95mm height with 20mm thickness.

Mount holes: none, self drill.

See the elastomer properties reference for general guidance on common rubber families and typical service ranges.

Compatibility and Fitment

To install the D Shape Rubber Bump Stop 900mm, fit it to a rigid surface so it can absorb impact without tearing. If you mount to steel, use suitable fasteners and spread the load with large washers or a backing strip. However, if you mount to timber, pre drill and use fixings that resist pull out so the buffer stays secure.

Before installation, clean the mounting face to remove grease and dust. Then mark your hole positions evenly along the length to avoid local stress points. If you need to drill through the buffer, use a sharp bit and steady pressure, otherwise the rubber can grab and wander.

When you cut the buffer, use a straight edge and a fine tooth saw so the end stays square. After that, keep the mounting face clean, because trapped grit can wear surfaces over time.

Compliance and Safety

This product is a protective buffer rather than a regulated safety device. Even so, secure mounting matters because loose buffers can become a hazard. If the buffer sits near moving gear, confirm clearance first so it cannot foul doors, ramps, or tailgates.

Trailer Applications

Use the D Shape Rubber Bump Stop 900mm on rear door frames, underbody contact points, and loading dock interfaces where repeated contact occurs. It also suits van and tipper bodies, so it helps protect both the body and the load during day to day work.

Why Choose ICS Trailers

ICS Trailers supports heavy vehicle operators with practical parts selection, consistent product data, and Australia wide supply so you can keep downtime low.

Browse Accessories & Consumables parts at ICS Trailers via Accessories & Consumables at ICS Trailers