Description

Overview

Outer swaged equaliser bush suits outer bush positions in equaliser, hanger and rocker assemblies where the stepped dimensions match the housing and pin arrangement. It supports controlled movement through the suspension pivot point, so the assembly can articulate under load without letting the housing pick up excess looseness.

When the bush wears, the joint can start to move around in the hanger or equaliser eye. That extra movement can bring noise, poor fit and faster wear across the surrounding hardware, so matching the dimensions matters before you press a replacement in.

Features

• Outer swaged equaliser bush for equalisers, hangers and rockers
• Stepped outside diameter of 96mm / 90mm
• Stepped inside diameter of 84mm / 78mm
• 55mm overall length for the outer bush position

Specifications and Materials

This bush uses a stepped profile, so the outside diameter measures 96mm / 90mm and the inside diameter measures 84mm / 78mm across a 55mm length. Those dimensions make it a selection-by-size part, especially when the suspension assembly has no readable markings left on the original bush.

Part number: SP1123.

See the SKF bushing mounting guide for general installation background

Compatibility and Fitment

Check the outer bush position, the stepped outside diameter, the stepped inside diameter and the full length before ordering. If the housing has worn out of round or the pin has picked up damage, measure both parts first because the outer swaged equaliser bush relies on the housing and bore profile matching the new bush correctly.

Compliance and Safety

Press the bush in square and support the housing properly during installation, otherwise you can damage the bush or distort the surrounding suspension eye. Also inspect the pin, hanger and equaliser eye for burrs, cracking or wear because a new bush will not correct damage in the mating parts.

Trailer Applications

This part suits mechanical suspension service work on trailer assemblies that run equalisers, hangers or rockers with a matching outer swaged bush arrangement. It also suits rebuild work where the suspension is already apart, because replacing a worn outer bush during teardown avoids rework once the assembly goes back together.

Why Choose ICS Trailers

This part suits dimension-based suspension repairs where the fitter needs a clear stepped size profile instead of a vague generic bush description. The outer swaged equaliser bush also covers three common mounting points, so it fits the kind of workshop job where the exact housing position still needs checking on the bench.

Browse Suspension parts at ICS Trailers