Description

Overview

Load Restraint Replacement Strap 50mm x 9m 2500kg gives you a simple way to replace a worn or cut webbing strap on a truck winch or load restraint setup. Because the strap includes a hook and keeper, you can swap like for like and get back to restraining freight with the same hardware you already run. It also comes with two wear sleeves, so you can protect the webbing where it rubs on rails and corners.

Features

• 50mm wide webbing with 9m strap length for common winch systems
• 2500kg lashing capacity rating for everyday restraint tasks
• Hook and keeper end fitting for quick attachment and secure seating
• Two wear sleeves to reduce abrasion at high-wear contact points

So, you can replace only the strap and keep the winch or tensioner you already trust.

Specifications and Materials

• Size: 50mm x 9m
• Capacity: 2500kg lashing capacity
• Webbing: nylon and polyester construction
• Included: 2 wear sleeves plus hook and keeper

Load Restraint Replacement Strap 50mm x 9m 2500kg suits common 50mm winch drums and tie rail setups.
Labelling may vary depending on availability.
Part number: CA4810.
Use the National Transport Commission load restraint guide to check best practice restraint methods for your load.

Compatibility and Fitment

This cross-reference listing means this part is a suitable replacement for the part numbers and applications shown. Some changes in installation may be required. No confirmed cross-reference part numbers are available for this item, so match your existing setup by strap width, length, and end fitting style.

Compliance and Safety

This strap is designed for load restraint applications and it complies with AS/NZS4380. Even so, inspect it before each trip, because damage can hide under sleeves and folds. If the webbing shows cuts, fraying, melted fibres, or stitching failure, replace it instead of trying to repair it. Also check the hook and keeper for deformation or corrosion so it seats properly under tension.

Trailer Applications

Load Restraint Replacement Strap 50mm x 9m 2500kg suits flat tops, tautliners, and other trailers that use tie rails or tracks with load restraint winches. It works well for palletised freight, crates, and machinery when you use edge protection and apply the correct restraint method for the load.

Cross-reference and Suitability

This item is usually selected by width, length, lashing capacity, and end fittings rather than by interchange numbers. If you are unsure, compare your existing strap and hardware, then choose the closest like-for-like replacement.

Why Choose ICS Trailers

You can get the right load restraint parts without guessing, because ICS Trailers can help you match strap width, length, and end hardware to your current winch setup. Browse Hardware at ICS Trailers in the Hardware category.