Description

Overview

The straight chassis pipe provides a rigid mounting arm for truck and trailer mudguards, spray suppression equipment and compatible chassis-mounted accessories. Its straight layout suits installations where the support can extend directly from the chassis without needing an offset to clear surrounding components.

This version combines a cast aluminium boss, 3-hole mounting pattern and Dura-Gal coated steel tube. The mounting arrangement spreads the load across the chassis connection while keeping the support tube aligned with the mudguard assembly.

Features

• Cast aluminium mounting boss
• Dura-Gal coated steel support tube
• 3-hole chassis mounting pattern
• Straight configuration for direct mudguard support

Specifications and Materials

Product type: straight chassis pipe and mounting boss assembly.

Mounting configuration: 3-hole cast aluminium boss.

Tube construction: Dura-Gal coated steel.

Product weight: 3.0 kg.

Part number: MGSTCPVPG.

Review the official Lelox mudguard and chassis pipe guide

Compatibility and Fitment

Confirm the straight mounting layout, 3-hole boss pattern, available tube reach and chassis clearance before ordering. Check that the pipe will clear tyres, suspension movement, air lines, wiring and the mudguard through the vehicle’s full operating range.

The boss must seat flat against the chassis or matching subplate. Do not substitute an offset, stainless steel or single-bolt chassis pipe where the installation requires this straight Dura-Gal 3-hole configuration.

These cross-references show where this part replaces the part numbers and applications listed. Some installations may need minor changes. MG STCP, MGSTCP, STCP, CA5571, LELSTCP

Related Parts

Check the related service parts below against the trailer setup before ordering.

Compliance and Safety

Mount the boss only to sound chassis material using fasteners suitable for the vehicle and installation. Support the mudguard assembly during fitment, tighten the mounting hardware correctly and check that the tube cannot contact tyres, suspension parts or brake components.

Inspect the boss, tube coating, chassis mounting area and fasteners during routine servicing. Replace the assembly if the tube is bent, the boss is cracked or the mounting holes have elongated.

Trailer Applications

Workshops fit this chassis pipe to trucks, semi-trailers and other heavy vehicles that require a straight support point for mudguards or spray suppression components. It also suits fabrication and replacement work where the existing installation uses a 3-hole straight chassis mount.

Cross-reference and Suitability

This part cross-references to or suits the following equivalent part numbers and compatible alternatives:

Why Choose ICS Trailers

ICS Trailers supplies mudguards, chassis mounting hardware and trailer body components for heavy vehicle repairs and fitment work. Send through the existing boss pattern, pipe layout and clear photos if the straight and offset versions are difficult to distinguish.

Browse more Trailer Parts