Description

Overview

KT pivot bolt kit secures the hanger to trailing arm pivot point on Fuwa K Hitch KT suspension setups. The kit suits suspension service where the pivot bolt hardware has worn, seized, stretched or been removed during bush replacement. Because the pivot point controls arm location and axle alignment, matching the correct KT pivot bolt kit matters before the trailer returns to service.

Features

• Pivot bolt hardware kit for KT air suspension service
• Suits the hanger to trailing arm pivot location
• Matches self-aligning 7/8″ pivot bolt applications
• Works with matching pivot bush and bush service kits

Specifications and Materials

The KT pivot bolt kit supports the main suspension pivot connection where the trailing arm locates through the hanger. Matched service data lists a 28.5mm bolt shaft, 320mm overall length, 88.5mm washer outside diameter, 12mm washer thickness, 42mm nut A/F and 25mm nut height. Part number: N100519-001.

Use the manufacturer KT suspension parts view for kit identification

Compatibility and Fitment

Check the suspension family, pivot bush, hanger and trailing arm before ordering. The KT pivot bolt kit appears in KT and KI suspension parts views as the pivot bolt kit for the hanger to trailing arm position, with two kits commonly listed per module. During alignment, tighten the pivot bolt only enough for the hardened washers to rotate, then finish torque after the suspension has been aligned and set at ride height.

These cross-references show where this part replaces the part numbers and applications listed. Some installations may need minor changes. SP1269

Related Parts

Check the related service parts below against the trailer setup before ordering.

Compliance and Safety

Install and torque this hardware with the suspension at ride height. Do not fully torque the pivot bolt before alignment, because the eccentric collars need movement to set the axle position correctly. Inspect the pivot bush at the same time, as collapsed or separated rubber can change the hanger position and affect axle alignment.

Trailer Applications

Trailer workshops use this hardware during KT suspension pivot repairs, bush replacement and hanger to trailing arm service work. Fleets also keep this bolt kit on hand when repairing Fuwa K Hitch air suspension modules after wear, corrosion or disassembly.

Cross-reference and Suitability

This part cross-references to or suits the following equivalent part numbers and compatible alternatives:

Why Choose ICS Trailers

ICS Trailers supplies suspension hardware for trailer repairs, axle alignment work and heavy vehicle maintenance. If the pivot bush or hanger hardware also needs attention, match the kit against the related parts before fitting. For more trailer suspension parts, browse the ICS Trailers Suspension Parts category